MSVKC - Multi-Stage Vertical Magnetic Sealed Pumps

  • Sealless magnetic drive
  • Polypropylene or PVDF construction
  • Pump length up to 65" long
  • 10 to 35 GPM flow 
  • 60 to 90 feet (39 PSI)
  • Robust design will allow high Specific Gravity solutions (1.5 to 1.8)
  • 9 1/2" x 14" x 3/4" thick PVC or CPVC mounting plate with 1 1/2" discharge piping 

Magnetic sealed pumps have provided reliable service however previous required that the pump be mounted remote from the tank and this would require bottom or side fitting in the tank.  With the piping exposed outside of the tank, it is subject to damage or leakage.

With the introduction of the Vertimag™, the requirement for a longer vertical pump can now be met.  The sealed nature of a magnetic driven pump offers better hydraulic efficiencies that most designs of vertical pumps without using support bushing within the liquid.  Introduction of air into the solution, a problem when using expeller type sealless vertical pumps for some applications, does not occur with the Vertimag™.  This vertical pump can be mounted inside or outside of the tank.

Vertimag™ combines the benefits of a magnetic driven sealless, the immersion advantage of the vertical and the ability of extended length of pump without external flush.  Multi-Stage design is for low flow applications, (10 to 35 GPM) that require higher pressures (60 to 90 feet) that a single stage impeller could provide.  Within the flow / pressure ranges, the amount of energy or horsepower used is reduced.  This will also provide for a smaller foot print, smaller and lighter weight motor.

The housing and column are constructed of molded polypropylene (or PVDF) for excellent corrosion resistance and strength.  Many of the parts used on the pump have been used for years on the KC Series magnetic driven pump.   The shaft is supported in a sealed column - modular in design - lengths are available in 9", 17", 23", 29", 35", 41", 47", 53", 59", and 65".  Motors are 1 1/2 HP, 2 HP or 3 HP - 56C frame (standard).

Design materials with options:

  • Polypropylene or PVDF (Kynar)
  • PVC mounting plate standard - CPVC optional
  • 9.5" x 14" x 3/4" thick mounting plate with custom sizes
  • Carbon impeller bushing standard - ceramic optional
  • PVDF bolts standard - Titanium or Hastelloy C optional

Performance curve 

Technical bulletin (dimensions)

IOM (parts)