High Flow design - 7 1/2 HP to 15
HP - flows 75 to 350 GPM
- Seal-less vertical immersion design
- CPVC construction
- Heavy duty service
- No bushing or bearing design - dry run capacity
- TEFC motors with air purge
- No solution contact with metals
- PVC or CPVC base plate incorporated discharge piping
- 3" discharge piping for low frictional loss
- 15 5/8" suction to plate dimension
- 17" x 24.25" cover plate
- 180 F temperature limit with standard materials
- Optional PVDF material impeller
- May be mounted intank or outside of tank
The HF design vertical pump is constructed using of a thick wall solid CPVC housing with 3" suction and discharge. The oversized one piece motor/pump shaft allows this pump to operate without support bushings. Open clearances between the pump and housing permit this pump to be subjected to dry running without a problem. A thick CPVC snap ring is used to hold the housing to the column.
Performance highlights:
| Model ( HP) | pressure at given flow rate | Max. flow | ||||
| @ 75 GPM | @ 150 GPM | @ 225 GPM | @ 275 GPM | @ 350 GPM | (recommended) | |
| P-7 1/2A-HF | 115 feet | 110 feet | 95 feet | n/a | n/a | 225 GPM |
| P-10 A - HF | 125 feet | 120 feet | 110 feet | 90 feet | n/a | 275 GPM |
| P-15 A - HF | 144 feet | 140 feet | 133 feet | 120 feet | 92 feet | 350 GPM |
Link to similar pump in extended length of 21.625"
Notes:
An increase of motor horsepower will be required for solutions with higher specific gravities. This pump will be engineered for the specific application. Solution data will be required for final pump selection. 20 HP motors upon request.
Estimated shipping weight of pump will be 300 to 320 pounds.
Bulletin 201-HF download - includes performance and dimensional information